As per our standard routine, this pump has been stripped down, sandblasted, re-assembled and repainted. To get to where it is now, it has had the following new parts fitted:

• cross-head pin and bush
• piston rod
• pinion and shaft
• stuffing box - complete
• aluminium pulley - 14", 2V A-section
• buckets x 2
• new bolts all round

The pump has 1.25" suction and discharge so your piping can be economical. This pump will push water to a head of 600 feet. At 300 rpm it will deliver approximately 400 gallons per hour - and it will only need 1.5 hp to do sol

Since the photos were taken, a suction chamber has also been fitted.

PLEASE NOTE - The top air chamber has had one lug welded as shown in the final photo below. This weld will not affect its performance nor its longevity.